Fix Your Stuff

Right to Repair

Store

Changes to Step #4

Edit by Taylor Dixon —

Edit approved by Taylor Dixon

Before
After
Unchanged

Step Lines

[* black] Use a spudger to lift up and disconnect the press connector connecting the battery/board assembly to the speaker drivers.
[* black] Once the cable is disconnected, remove the assembly from the bud.
[* icon_reminder] During reassembly, slide battery/board assembly into the earbud so that [https://d3nevzfk7ii3be.cloudfront.net/igi/pfrLXpnaTTcOQ1Ub.full|thehttps://d3nevzfk7ii3be.cloudfront.net/igi/SHx2qkM5tov4IQml.full|the peg from the outer case fits into the notch in the battery housing|new_window=true]. Then reattach the connector to reconnect the assembly.
[* icon_reminder] During reassembly, slide battery/board assembly into the earbud so that [https://d3nevzfk7ii3be.cloudfront.net/igi/pfrLXpnaTTcOQ1Ub.full|thehttps://d3nevzfk7ii3be.cloudfront.net/igi/SHx2qkM5tov4IQml.full|the peg from the outer case fits into the notch in the battery housing|new_window=true]. Then reattach the connector to reconnect the assembly.