Skip to main content

Changes to Step #1

Edit by Jeff Suovanen

Edit approved by Jeff Suovanen

Before
After
Unchanged

Step Lines

-[* black] Use a plastic opening tool to gently pry the digitizer connector up from its socket on the logic board.
-[* icon_caution] Be very careful to pry evenly on the connector, and not on the socket at all. The socket and connector are very delicate and if you damage either, your digitizer won't work.
+[* icon_caution] Be very careful to pry evenly on the digitizer connector, and not on the socket at all. The socket and connector are very delicate and if you damage either, your digitizer won't work.
+ [* black] To minimize stress on the socket, try prying under the short edge of the connector, rather than the long edge which is shown in these images.
+[* black] Gently pry the digitizer connector up from its socket on the logic board.