Skip to main content

Changes to Step #1

Edit by Walter Galan

Edit approved by Walter Galan

Deleted
Added
Unchanged

Step Lines

[* red] Remove the three 1.3 mm Phillips #00 screws securing the connector shield to the logic board.
[* black] On reassembly, beicon_caution] Be sure not to not substitute these three screws forwith any other screws, specifically the similar screws used to attachsecuring the large LCD shield. Thoseshield plate to the rear case of the iPad. Any slightly longer screws will breakmay strip the screw bracketsholes and result in irreparable damage to the motherboardlogic board.
[* black] On reassembly, beicon_caution] Be sure not to not substitute these three screws forwith any other screws, specifically the similar screws used to attachsecuring the large LCD shield. Thoseshield plate to the rear case of the iPad. Any slightly longer screws will breakmay strip the screw bracketsholes and result in irreparable damage to the motherboardlogic board.