Skip to main content

Changes to Step #10

Edit by Andrew Optimus Goldheart

Edit approved by Andrew Optimus Goldheart

Deleted
Added
Unchanged

Step Lines

[* icon_note] In the next few steps, you'll be sliding a spudger between the LCD and the metal backing plate to fully separate the LCD from the adhesive beneath.
[* black] Insert the flat end of a spudger between the LCD frame and the metal backing plate.
[* icon_caution] Be sure to get the spudger between the LCD frame and backing plate, and not beneath the plate. ThePrying up on the plate will damage it, because it is screwed down to the rear case, so prying up on it will damage itcase beneath the LCD.
[* icon_caution] Be sure to get the spudger between the LCD frame and backing plate, and not beneath the plate. ThePrying up on the plate will damage it, because it is screwed down to the rear case, so prying up on it will damage itcase beneath the LCD.