Skip to main content

Changes to Step #1

Edit by Sam Goldheart

Edit approved by Sam Goldheart

Before
After
Unchanged

Step Lines

-[* icon_note] The camera bracket is attached to the front panel by adhesive. The use of a heat gun to soften the adhesive is highly recommended.
-[* black] With the heat gun set on "low", begin heating the perimeter around the camera bracket.
-[* icon_reminder] It is suggested to heat the desired portion in a circular motion pattern to evenly dissipate the amount of heat throughout the device.
+[* icon_note] The camera bracket is attached to the front panel by adhesive. The use of an iOpener to soften the adhesive is highly recommended.
+[* black] Place the iOpener in the microwave and microwave it for ***one minute*** on the highest power setting.
+ [* icon_caution] Be careful not to overheat the iOpener during the repair procedure. We recommend waiting at least two minutes before reheating the iOpener.
+[* icon_reminder] Place the iOpener over the front facing camera on the front edge of the top of the display.

Image 1

Old Version

New Version