Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Changes to Step #20

Edit by Andrew Optimus Goldheart

Edit approved by Andrew Optimus Goldheart

Deleted
Added
Unchanged

Step Lines

[* black] Push a guitarSlide the lower left pick in betweento the front panel and rear case near the toplower left corner ofto cut the iPadadhesive on that corner.
[* black] SlideLeave the guitar pick towardat the front-facing camera to breakcorner. Do not pry any farther, and do not remove the layer of adhesivepick from the iPad.
[* icon_note] There are quite a few things to avoid
beneath the top display bezel.
[* icon_caution] Stop once you reach
lower bezel, so study the camera, as you might damage the camera or itsthird image closely:
[* red] Antennas
[* orange] Home button cavity
[* yellow] Digitizer
cable if
[* black] The following steps will direct
you slide the guitar pick over the camerawhere to pry to avoid damage to these components. Only apply heat and pry where directed.
[* black] Push a guitarSlide the lower left pick in betweento the front panel and rear case near the toplower left corner ofto cut the iPadadhesive on that corner.
[* black] SlideLeave the guitar pick towardat the front-facing camera to breakcorner. Do not pry any farther, and do not remove the layer of adhesivepick from the iPad.
[* icon_note] There are quite a few things to avoid
beneath the top display bezel.
[* icon_caution] Stop once you reach
lower bezel, so study the camera, as you might damage the camera or itsthird image closely:
[* red] Antennas
[* orange] Home button cavity
[* yellow] Digitizer
cable if
[* black] The following steps will direct
you slide the guitar pick over the camerawhere to pry to avoid damage to these components. Only apply heat and pry where directed.

Image 1

Old Version

New Version

Image 2

Old Version

New Version

Image 3

No previous image

Added