Skip to main content

Changes to Step #33

Edit by Arthur Shi

Edit approved by Arthur Shi

Deleted
Added
Unchanged

Step Lines

[* black] Lift the bottom edge of the battery up slightly.
[* icon_note] Do not hinge the battery beyond 45 degrees, or you risk damaging the inter-cell connectors.
[* black] Use tweezers or your fingers to peel the clear plastic covering off of the entire bottom side of the battery.
[* icon_note] At this point, the battery's four adhesive strips are exposed. Be careful handling the battery and try not to touch the strips.
[* black] Use tweezers or your fingers to peel the clear plastic covering off of the entire bottom side of the battery.
[* icon_note] At this point, the battery's four adhesive strips are exposed. Be careful handling the battery and try not to touch the strips.
[* black] Align the battery such that it falls in place with the [https://d3nevzfk7ii3be.cloudfront.net/igi/WKClaO1XpwZNsg1D.full|screw post|new_window=true] near the Smart Connector.
[* black] Gently lay the battery down into its recess. Be sure not to trap the Smart Connector cable underneath the battery.
[* black] Press your fingers across the surface of the battery where the adhesive strips would be in order to activate the adhesive.