Skip to main content

Changes to Step #30

Edit by Arthur Shi

Edit approved by Arthur Shi

Deleted
Added
Unchanged

Step Lines

[* icon_reminder] The following steps detail how to re-install a new battery.
[* black] Thoroughly clean the back case of all adhesive residue.
[* black] Apply adhesive remover or high concentration (over 95%) isopropyl alcohol to the residue.
[* black] Use an opening tool to scrape and loosen the residue.
[* black] Wipe the residue away with paper towels. Be sure to wipe in one direction to prevent smearing.
[* icon_note] It is easier to wipe off the residue when it is sufficiently soaked. Once it starts drying up, the residue becomes incredibly tacky.
[* icon_note] If you used adhesive remover, be sure to wipe the area down with isopropyl alcohol to remove any adhesive remover residue.
[* black] You can remove the masking tape as well as any protective gear once you are done cleaning.