Changes to Step #29
Edit by Adam O'Camb —
Edit approved by Adam O'Camb
- Before
- After
- Unchanged
Step Lines
[* icon_note] The goal is to lift the battery contacts high enough |
[* icon_note] The goal is to lift the battery contacts high enough |
[* black] Slowly lever the battery disconnect tool upwards, pushing the battery contacts and the logic board up. |
[* icon_note] The logic board is held to the rear case with strong adhesive. Try to lift just enough to loosen the adhesive surrounding the connector. |
[* icon_caution] Do not lift the logic board up to the point where the top and bottom edge of the logic board |
[* icon_caution] Do not lift the logic board up to the point where the top and bottom edge of the logic board |
[* black] Once the battery disconnect tool has lifted the battery contacts high enough to clear the screw post, pull the battery out of its position. |
[* black] Remove the battery and the battery disconnect tool. |