Skip to main content

Changes to Step #13

Edit by Arthur Shi

Edit approved by Arthur Shi

Deleted
Added
Unchanged

Step Lines

[* black] Carefully insert a plastic card under the bottom right corner of the battery.
[* black] Slowly slide the plastic card across the bottom edge of the battery to make a gap for the liquid adhesive remover.
[* icon_note] At this point, you do not need to push the card very deep under the battery. 0.5 inches (13 mm) is more than sufficient.
[* icon_noteicon_caution] While some bending of the battery pack will be inevitable, try not to form any sharp creases, which will compromise the battery structurestructure and potentially trigger a fire hazard.
[* icon_noteicon_caution] While some bending of the battery pack will be inevitable, try not to form any sharp creases, which will compromise the battery structurestructure and potentially trigger a fire hazard.