Changes to Step #3
Edit by Arthur Shi —
Edit approved by Arthur Shi
- Deleted
- Added
- Unchanged
Step Lines
| [* black] Use tweezers or a spudger to gently pull up the end of the black tape nearest the Smart Connector. It covers the mid-battery circuit board residing between the two battery cells. |
| [* icon_note] You only need to peel the tape back enough to reveal the connector underneath. |
| [* red] Remove the 1.7 mm Phillips screw holding the Smart Connector cable cover in place. |
| [* black] Remove the Smart Connector cable cover. |