Skip to main content

Changes to Step #2

Edit by B0NK3R5

Edit approved by B0NK3R5

Before
After
Unchanged

Step Lines

[* black] Start by taking the screws from around the frame off.
[* black] Then remove the screws from this PCB
-[* black] If you are replacing screen components, skip to step X
+[* black] If you are replacing screen components, skip to step 7
[* black] Remove the little foam pads from the two connectors on the PCB These are for the digitizer
[* black] Flip up the releases on the plugs to pull out the ribbon cable. (I will show some more detailed pictures of the same process on other connectors.