Skip to main content

Changes to Step #2

Edit by B0NK3R5

Edit approved by B0NK3R5

Before
After
Unchanged

Step Lines

+[* black] Start by taking the screws from around the frame off.
+[* black] Then remove the screws from this PCB
+[* black] If you are replacing screen components, skip to step X
+[* black] Remove the little foam pads from the two connectors on the PCB These are for the digitizer
+[* black] Flip up the releases on the plugs to pull out the ribbon cable. (I will show some more detailed pictures of the same process on other connectors.

Image 1

No previous image

Added