Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #3

Edit by Paul Barnfather

Edit approved by Paul Barnfather

Before
After
Unchanged

Step Lines

[title] Remove the 6V parts
[* black] Disconnect and remove the 6V battery
[* icon_note] The 12V system is quite a bit simpler than the Wipac system, as there's no longer a need to switch the alternator output with the headlight. It's probably easier to refer to the differences in the wiring diagram pictures to see what needs to be removed...
[* black] Disconnect and remove the 6V battery. Note the brown wire that went to the negative terminal; we'll be connecting the 12V battery positive terminal to the later (via a 10A fuse).
[*
black] Disconnect and remove the rectifier, noting the brown wire that connectswent to the rectifier negative terminal (you'll be connecting the 12V regulator to this wire later...)
[* black] Disconnect and remove the 6V battery. Note the brown wire that went to the negative terminal; we'll be connecting the 12V battery positive terminal to the later (via a 10A fuse).
[*
black] Disconnect and remove the rectifier, noting the brown wire that connectswent to the rectifier negative terminal (you'll be connecting the 12V regulator to this wire later...)
[* black] Remove the orange, light green and white wires as well as the resistance wire from the main loom
[* black] Remove the 6V ignition coil
[* black] Remove the headlamp bulb, sidelight bulb, stop/tail bulb (and any other 6V bulbs)