Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #4

Edit by Paul Barnfather

Edit approved by Paul Barnfather

Before
After
Unchanged

Step Lines

[title] Fit the regulator
[* black] Disconnect the three wires from the alternator
[* black] Remove the 6V battery
[* black] Remove the XXX
[* black] Fit the regulator somewhere convenient (above or below the coil is a good option)
[* black] Fit the new 12V battery. A xxxx fits in the existing tray just fine. Use a bit of foam to isolate the battery from the engine vibration and a rubber strap to hold it in place.
[* black] Connect the three yellow wires from the regulator to the three alternator wires. It doesn't matter which one goes to which.