Skip to main content

Changes to Step #5

Edit by Jeff Suovanen

Edit approved by Jeff Suovanen

Before
After
Unchanged

Step Lines

+[* black] Gently slide a plastic card or other thin pry tool under the adhered component.
+ [* icon_note] It may help to gently wiggle or twist the card as you go. If you're separating a battery, be careful not to deform or puncture it.
+[* black] If you're struggling, apply a few more drops of adhesive remover and wait about a minute before trying again.
+[* black] If your device has an especially tight fit and you have trouble inserting a tool, try working a piece of floss or wire underneath the component, and pull it side-to-side in a sawing motion to separate the adhesive.
+[* black] Lift and separate your newly-unglued component.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added