Changes to Step #11
Edit by Adam O'Camb —
Edit approved by Adam O'Camb
- Before
- After
- Unchanged
Step Lines
| + | [* icon_note] The top edge of the display is secured with both glue and clips. |
|---|---|
| + | [* black] Slide the opening pick around the top corner of the display, while gently pulling or wiggling the display ***''down''*** in the direction of the Lightning port. |
| + | [* icon_caution] The clips will break if you use too much force. Work carefully and be patient. |
| + | [* icon_caution] Again, don't insert the pick more than a few millimeters—about the width of the display bezel—or you may damage the front panel sensor array. |
| + | [* black] Slide the pick to the opposite corner and cut any remaining adhesive securing the display. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added