Skip to main content

Changes to Step #1

Edit by mayer

Edit approved by Arthur Shi

Before
After
Unchanged

Step Lines

[* black] Use a T6 Torx driver to remove the four 7.2 mm screws securing the fan:
[* red] Two screws securing the fan to the logic board
- [* orange] Two screws securing the fan to the exhaust vent
+ [* orange] Two 7.2 mm screws with rubber shoulders securing the fan to the exhaust vent
[* icon_note] Rubber grommets secure these screws to the fan, so they may not come out completely. Just make sure they are fully loosened.