Skip to main content

Changes to Step #1

Edit by Jeff Suovanen

Edit approved by Jeff Suovanen

Before
After
Unchanged

Step Lines

+[* black] Use a T6 Torx driver to remove the four 7.2 mm screws securing the fan:
+ [* red] Two screws securing the fan to the logic board
+ [* orange] Two screws securing the fan to the exhaust vent
+[* icon_note] Rubber grommets secure these screws to the fan, so they may not come out completely. Just make sure they are fully loosened.

Image 1

No previous image

Added

Image 2

No previous image

Added