Skip to main content

Changes to Step #3

Edit by Tobias Isakeit

Edit approved by Tobias Isakeit

Before
After
Unchanged

Step Lines

-[* icon_note] Open the MacBook Pro a little wider than 90 degrees, and place it with one end on the table, as shown.
-[* red] Remove the three T9 Torx screws from the upper display bracket. Hold the display with your left hand while doing so.
+[* icon_note] Open the MacBook Pro a little wider than 90 degrees, and place it on end on the table, as shown.
+[* red] While holding the display with your left hand remove the three T9 Torx screws from the upper display bracket.
[* icon_caution] Be sure the display and upper case are balanced and will not fall over, potentially damaging other components.
-[* orange] Remove the three T9 Torx screws from the lower display bracket. Hold the display with your left hand during this procedure.
+[* orange] Remove the remaining three T9 Torx screws from the lower display bracket.