Fix Your Stuff

Right to Repair

Store

Changes to this Step

Edit by Adam O'Camb —

Edit approved by Adam O'Camb

Before
After
Unchanged

Step Lines

[* black] WhenBefore installing the new component,component or removing the adhesive backing, make sure the replacement part fits, and that all connectors will connect to their respective sockets correctly without putting undue stress on their cables.
[* black] For parts with rigid cables (like some batteries), connect the part before installing it, and leave it connected during installation, to make sure the part is positioned correctly.
[* black] Peel the backing off the adhesive and carefully install the replacement part.
[* black] Apply even pressure over the whole adhesion surface for at least 30 seconds to strengthen the bond.
[* black] WhenBefore installing the new component,component or removing the adhesive backing, make sure the replacement part fits, and that all connectors will connect to their respective sockets correctly without putting undue stress on their cables.
[* black] For parts with rigid cables (like some batteries), connect the part before installing it, and leave it connected during installation, to make sure the part is positioned correctly.
[* black] Peel the backing off the adhesive and carefully install the replacement part.
[* black] Apply even pressure over the whole adhesion surface for at least 30 seconds to strengthen the bond.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added