Skip to main content

Changes to Step #27

Edit by Justin

Edit approved by Justin

Before
After
Unchanged

Step Lines

+[* black] Back on the driver's side...
+[* black] Connect the two fuel lines inside the fuel tank to the fuel filter assembly.
+[* black] These lines are different sizes so you can't mix them up.
+[* black] Again, press these lines on until you hear or feel a click. You shouldn't be able to remove the hose by pulling on it (unless you press the release tab).
+[* black] Place the new gasket in place on the fuel tank as shown. Clean the mating edge of the fuel tank first so you get a good seal.
+[* black] Continue connecting the electrical connections to the fuel filter assembly. These connections should be the same as when you removed the original fuel filter assembly.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added