Skip to main content

Changes to this Step

Edit by Dominik Schnabelrauch

Edit approved by Dominik Schnabelrauch

Deleted
Added
Unchanged

Step Lines

[* black] Insert wisdom hereicon_note] Open the MacBook Pro a little wider than 90 degrees, and place it on end on the table, as shown.
[* red] Remove the three T9 Torx screws from the upper display bracket. Hold the display with your left hand while doing so.
[* icon_caution] Be sure the display and upper case are balanced and will not fall, potentially damaging each component.
[* orange] Remove the three T9 Torx screws from the lower display bracket. Hold the display with your left hand during this procedure
.
[* black] Insert wisdom hereicon_note] Open the MacBook Pro a little wider than 90 degrees, and place it on end on the table, as shown.
[* red] Remove the three T9 Torx screws from the upper display bracket. Hold the display with your left hand while doing so.
[* icon_caution] Be sure the display and upper case are balanced and will not fall, potentially damaging each component.
[* orange] Remove the three T9 Torx screws from the lower display bracket. Hold the display with your left hand during this procedure
.

Image 1

Old Version

New Version

Image 2

Old Version

New Version