Skip to main content

Changes to Step #3

Edit by Noah

Edit approved by Noah

Before
After
Unchanged

Step Lines

-[* black] Attach synchronization device to the other carburetor.
-[* red] Using a flathead screw-driver, twist the screw in to raise the reading, and loosen to lower it
-[* black] The goal is the meet the two values halfway
- [* black] So, if one is higher than the other, lower the high one, and raise the low on until they meet in the middle
+[* black] Set the synchronization device on the other carburetor.
+[* red] Using a Flathead screw-driver, twist the idle speed screw in to raise the flow, and out to lower it.
+[* black] Recheck both carburetors and adjust as needed to get the flow as equal as possible.

Image 1

Deleted