Changes to Step #8
Step Lines
| - | [* black] 用热风枪加热，上盖金属连接部件，这里温度要稍微高一些，大概在90到100多度左右，加热20几秒后，（注意环境温度和加热，时间成反比）最后用尖嘴钳夹住金属连接扣两边，左右摇晃，用力拉出 |
|---|---|
| + | [* green] Heat with a hot air gun, cover the metal connecting parts, the temperature here is slightly higher, about 90 to more than 100 degrees, after heating for 20 seconds. |
| + | [* violet] (note the ambient temperature and heating, the time is inversely proportional), finally use the needle-nosed pliers Hold the metal connecting buckle on both sides, shake it from side to side, pull out hard |