Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Changes to Step #6

Edit by David Sylvester

Edit approved by David Sylvester

Deleted
Added
Unchanged

Step Lines

[* yellow] Remove the two 15 mm Phillips #0 screws holding the DLP heat sink to the light engine board.
[* icon_caution] Springs underneath the screws help hold the heat sink on top of the DLP chip. During reassembly do not tighten the screws down all the way. Doing so can damage the DLP chip.
[* yellow] Remove the two 15 mm Phillips #0 screws holding the DLP heat sink to the light engine board.
[* icon_caution] Springs underneath the screws help hold the heat sink on top of the DLP chip. During reassembly do not tighten the screws down all the way. Doing so can damage the DLP chip.