Changes to Step #1
Edit by Vinu Weerasinghe —
Edit approved by Vinu Weerasinghe
- Before
- After
- Unchanged
Step Lines
| [* black] Remove the grey scuff guard at the bottom of the PC by pressing down on it, and pulling it away. |
| [* black] Lift the hinge and remove the grey rubber tabs on either side of the PC’s model information. |
| [* red] Remove the two 7.62mm Phillips #1 screws beneath the rubber tabs under the hinge and the four 7.62mm Phillips #1 screws where the scuff guard was removed. [* orange] Remove the two 4.74mm Phillips #1 screws under the hinge (near the hinge joints) and a 4.74mm Phillips #1 screw under the handle. |
| [* red] Remove the two 7.62mm Phillips #1 screws beneath the rubber tabs under the hinge and the four 7.62mm Phillips #1 screws where the scuff guard was removed. [* orange] Remove the two 4.74mm Phillips #1 screws under the hinge (near the hinge joints) and a 4.74mm Phillips #1 screw under the handle. |