Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #13

Edit by dsurati1

Edit declined by Andrew Optimus Goldheart

Before
After
Unchanged

Step Lines

[* black] Remove the following screws securing the front panel assembly cable bracket to the logic board:
[* red] Two 1.2 mm Phillips screws
[* orange] One 1.6 mm Phillips screw
[* icon_note]icon_caution] TAKE EVERY PRECAUTION TO PLACE THE 1.6 MM PHILLIPS SCREW WHERE IT BELONGS FOR RE-ASSEMBLY OTHERWISE YOU WILL END UP DAMAGING THE LOGIC BOARD!! This screw tends to not be attracted to a magnetized screwdriver. Take care not to lose it when removing, and make sure it gets back into the right place—a magnetized screw may interfere with the compass.
[* icon_note]icon_caution] TAKE EVERY PRECAUTION TO PLACE THE 1.6 MM PHILLIPS SCREW WHERE IT BELONGS FOR RE-ASSEMBLY OTHERWISE YOU WILL END UP DAMAGING THE LOGIC BOARD!! This screw tends to not be attracted to a magnetized screwdriver. Take care not to lose it when removing, and make sure it gets back into the right place—a magnetized screw may interfere with the compass.