Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #13

Edit by Andrew Optimus Goldheart

Edit approved by Andrew Optimus Goldheart

Before
After
Unchanged

Step Lines

[* black] Remove the following screws securing the front panel assembly cable bracket to the logic board:
[* red] Two 1.2 mm Phillips screws
[* orange] One 1.6 mm Phillips screw (Note this 1.6 mm
[* icon_note] This
screw is different than the 1.6mm screw in step 10, this one is non-magnetic,tends to not be sureattracted to keep track of which 1.6 is whicha magnetized screwdriver. Take care not to avoid interferinglose it when removing, and make sure it gets back into the right place—a magnetized screw may interfere with the compass.)compass.
[* orange] One 1.6 mm Phillips screw (Note this 1.6 mm
[* icon_note] This
screw is different than the 1.6mm screw in step 10, this one is non-magnetic,tends to not be sureattracted to keep track of which 1.6 is whicha magnetized screwdriver. Take care not to avoid interferinglose it when removing, and make sure it gets back into the right place—a magnetized screw may interfere with the compass.)compass.