Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #13

Edit by Matt

Edit approved by Andrew Optimus Goldheart

Before
After
Unchanged

Step Lines

[* black] Remove the following screws securing the front panel assembly cable bracket to the logic board:
[* red] Two 1.2 mm Phillips screws
[* orange] One 1.6 mm Phillips screw (Note this 1.6 mm screw is different than the 1.6mm screw in step 10, this one is non-magnetic, be sure to keep track of which 1.6 is which to avoid interfering with the compass.)
[* orange] One 1.6 mm Phillips screw (Note this 1.6 mm screw is different than the 1.6mm screw in step 10, this one is non-magnetic, be sure to keep track of which 1.6 is which to avoid interfering with the compass.)