Skip to main content

Changes to Step #9

Edit by David42

Edit approved by David42

Deleted
Added
Unchanged

Step Lines

[title] Remove the DMD opticsSeparate the front lens section
[* black] Remove 3 silver 12mm Philips #2 screws joining the DMD optical section to the front lenselens. The three screws cannot be seen in one picture, so three pictures are attached.
[title] Remove the DMD opticsSeparate the front lens section
[* black] Remove 3 silver 12mm Philips #2 screws joining the DMD optical section to the front lenselens. The three screws cannot be seen in one picture, so three pictures are attached.
[* red] The top screw is visible as you look down on the unit.
[* orange] The left hand screw is seen as you look along the left hand underside of the DMD heat sink
[* yellow] The right hand screw is visible as you look along the right hand underside of the DMD heat sink.