Skip to main content

Changes to Step #3

Edit by David42

Edit approved by David42

Deleted
Added
Unchanged

Step Lines

[title] Remove the mirror cover plates
[* red] Remove these 6 black 5mm Philips #2 screws to release the two plastic covers on the front of the mirror area.
[* orange] Remove these 2 black 5mm Philips #2 screws to release the plastic bar that supported the front cover.
[* yellow] Remove these 2 black 5mm Philips #2 screws to release the metal bar that attached the support for the front cover.
[* green] Remove these 2 black 5mm Philips #2 screws that are attaching the back mirror cover..
[* black] Gently bend the back mirror cover to release the remote control receiver from the metal mirror mounting that it is hooked into. Then pull the mirror cover right back to unhook the plastic clips from the main projector.
[* icon_note] The plastic mirror is attached with rivets so it cannot be removed without damage. The projector I used for the later stages of this teardown has a missing mirror..