Skip to main content

Changes to Step #2

Edit by David42

Edit approved by David42

Deleted
Added
Unchanged

Step Lines

[title] Remove electrical componentsthe power supplies
[* red] Remove these 4 silver 6mm Philips #2 screws to release the top power supply.
[* orange] Peel off this cardboard that is glued to the power supply cover.

[* black] Unplug the large plug at each end of the power supply and the smaller fan wire. You can now remove the top power supply.
[* green]
Remove these 4 silver 8mm Philips #2 screws from the bulb, main board,lower power supply and twounplug the small wire. You can now remove the power supplies as described insupply and the pre-requisite guide "Smart UF75 DMD chip Replacement"card it is sitting on.
[title] Remove electrical componentsthe power supplies
[* red] Remove these 4 silver 6mm Philips #2 screws to release the top power supply.
[* orange] Peel off this cardboard that is glued to the power supply cover.

[* black] Unplug the large plug at each end of the power supply and the smaller fan wire. You can now remove the top power supply.
[* green]
Remove these 4 silver 8mm Philips #2 screws from the bulb, main board,lower power supply and twounplug the small wire. You can now remove the power supplies as described insupply and the pre-requisite guide "Smart UF75 DMD chip Replacement"card it is sitting on.

Image 1

Old Version

New Version

Image 2

No previous image

Added