Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to this Step

Edit by Adam O'Camb

Edit approved by Adam O'Camb

Before
After
Unchanged

Step Lines

[* black] Peel off the four black tamper-evident stickers covering the heat sink mounting screws.
[* red] Remove the four T10 screws that secure the heat sink from the backside of the logic board.
[* icon_reminder] During reassembly, tighten these screws one full turn at a time, [https://d3nevzfk7ii3be.cloudfront.net/igi/Mkb4dN2AH1AGwe3F|alternating in a cross pattern|new_window=true]. This will gradually increase the clamping pressure evenly across the surface of the CPU. Continue gradually tightening the screws until they're snug and the entire spring plate [https://d3nevzfk7ii3be.cloudfront.net/igi/1NED52iMbNDN3NUF|lays flat|new_window=true] against the logic board.

Image 1

No previous image

Added

Image 2

No previous image

Added