Skip to main content

Changes to Step #1

Edit by Kristen Gismondi

Edit approved by Kristen Gismondi

Before
After
Unchanged

Step Lines

[* red] Place the T9 Torx screwdriver in the screw slot and turn counterclockwise to extract the single 14 mm screw.
-[* orange] Using the Blunt Tweezers, detach the spring by grasping the end attached to the fuser assembly and pulling out and away.
-[* yellow] Using the Blunt Tweezers, remove the black, ribbed washer by prying away from the print rail.
+[* orange] Using the blunt tweezers, detach the spring by grasping the end attached to the fuser assembly and pulling out and away.
+[* yellow] Using the blunt tweezers, remove the black, ribbed washer by prying away from the print rail.