Skip to main content

Changes to Step #1

Edit by Nicholas Greco

Edit approved by Nicholas Greco

Before
After
Unchanged

Step Lines

-[* red] Using the T9 Torx screwdriver, unscrew the single 14 mm screw.
+[* red] Place the T9 Torx screwdriver in the screw slot and turn counterclockwise to extract the single 14 mm screw.
[* orange] Using the Blunt Tweezers, detach the spring by grasping the end attached to the fuser assembly and pulling out and away.
[* yellow] Using the Blunt Tweezers, remove the black, ribbed washer by prying away from the print rail.