Skip to main content

Changes to Step #1

Edit by Nicholas Sheffler

Edit approved by Nicholas Sheffler

Before
After
Unchanged

Step Lines

-[* red] Using the T9 Torx screwdriver, unscrew the single 14mm screw.
-[* orange] Using the Blunt Tweezers, detach the spring by grasping the end attached to the fuser assembly and pulling out and away.
+[* red] Using the T9 Torx screwdriver, unscrew the single 14 mm screw.
+[* orange] Using the Blunt Tweezers, detach the spring by grasping the end attached to the fuser assembly and pulling out and away.
[* yellow] Using the Blunt Tweezers, remove the black, ribbed washer by prying away from the print rail.