Skip to main content

Changes to Step #1

Edit by Nicholas Greco

Edit approved by Nicholas Greco

Before
After
Unchanged

Step Lines

-[* black] Using the T9 Torx screwdriver, unscrew the single 14mm screw.
-[* black] Using the pliers
+[* red] Using the T9 Torx screwdriver, unscrew the single 14mm screw.
+[* orange] Using the Blunt Tweezers, detach the spring by grasping the end attached to the fuser assembly and pulling out and away.
+[* yellow] Using the Blunt Tweezers, remove the black, ribbed washer by prying away from the print rail.

Image 2

Old Version

New Version