Skip to main content

Changes to Step #2

Edit by Nicholas Greco

Edit approved by Nicholas Greco

Before
After
Unchanged

Step Lines

[* red] Using the Blunt Tweezers, remove the spring via the same method outlined in the previous step.
-[* black] Firmly grasp the print rail and gently pull it out of its slot in the fuser assembly.
+[* black] Firmly grasp the print rail and gently guide it out of the slot in the fuser assembly by pulling away from the printer body.
[* icon_note] Because this rail is what guides the printhead, it will be greased. Dress accordingly to avoid unwanted stains.
[* icon_note] Because the printhead sits on this rail, be sure to brace the printhead as you retract the print rail to avoid any unwanted damage.