Skip to main content

Changes to Step #3

Edit by Jeff Suovanen

Edit approved by Jeff Suovanen

Before
After
Unchanged

Step Lines

+[* black] Pull up on the suction cup with firm, constant pressure to create a slight gap between the front panel and rear case.
+[* black] Insert an opening pick or other thin pry tool a few millimeters into the gap.
+ [* icon_note] The watertight adhesive holding the display in place is very strong; creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, apply more heat, and gently rock the screen up and down to weaken the adhesive until you create enough of a gap to insert your tool.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added