Skip to main content

Changes to Huawei Honor 9 Battery Replacement Introduction

Edit by Dominik Schnabelrauch

Edit approved by Dominik Schnabelrauch

Before
After
Unchanged
Device
[ … ]Huawei Honor 9
Type
[ … ]replacement
Thing
[ … ]Battery
Title
[ … ]Huawei Honor 9 Battery Replacement
Introduction
Use this guide to remove the battery in the Huawei Honor 9. [ … ] Before disassembling your phone, discharge the battery below 25%. [[What to do with a swollen battery|If your battery is swollen]], do not heat your phone. Swollen batteries can be very dangerous, so wear eye protection and exercise due caution, or take it to a professional if you're not sure how to proceed. [ … ] You’ll need replacement adhesive to reattach components when reassembling the device.
Time Required Min
35 minutes
Time Required Max
1 hour
Imageid
Before
After
Difficulty
Difficult
Conclusion
To reassemble your device, follow these instructions in reverse order. [ … ] '''If possible''', turn on your phone and '''test your repair''' before installing new adhesive and resealing the phone. [ … ] '''Secure the new battery''' with pre-cut adhesive or double-sided adhesive tape. In order to position it correctly, apply the new adhesive into the phone at the places where the old adhesive was located, not directly onto the battery. Press the new battery firmly into place for 5-10 seconds. [ … ] For optimal performance, [[Battery Calibration|calibrate]] your newly installed battery: Charge it to 100%, and keep charging it for at least two more hours. Then, use it until it shuts off due to low battery. Finally, charge it uninterrupted to 100% [ … ] Take your e-waste to an [[E-Waste|R2 or e-Stewards certified recycler|new_window=true]]. [ … ] To reassemble your device, follow these instructions in reverse order. [ … ] Repair didn’t go as planned? Check out our [https://www.ifixit.com/Answers/Device/Huawei%20Honor%209|Answers community] for troubleshooting help.
Author
Public
No
Summary
[ … ]This guide shows how to remove the battery in the Huawei Honor 9.

Guide Prerequisites

Tools

  • Suction Handle x1 added.
  • iFixit Opening Picks set of 6 x1 added.
  • iOpener x1 added.
  • Phillips #00 Screwdriver x1 added.
  • Spudger x1 added.
  • iFixit Adhesive Remover (for Battery, Screen, and Glass Adhesive) x1 added.
  • Plastic Cards x1 added.

Parts

  • Huawei P10 and Honor 9 Replacement Battery x1 added.

Flags

  • In Progress added.

Steps

Step #: 1
Before
After
Step #: 2
Before
After
Step #: 3
Before
After
Step #: 4
Before
After
Step #: 5
Before
After
Step #: 6
Before
After