Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Drawer Track Alignment Spacer Introduction

Edit by Bryan Arrington

Edit approved by Bryan Arrington

Before
After
Unchanged
Device
[ ]Kitchen Drawer Tracks
Type
[ ]replacement
Thing
[ ]Spacer
Title
[ ]Kitchen Drawer Track Spacer
Introduction
[ ]This iFixit guide shows you how to fix your misaligned drawer tracks or rollers that fall out of their tracks using a 3d printed spacer.
Time Required Min
20 minutes
Time Required Max
20 minutes
Imageid
Before
After
Difficulty
Moderate
Author
Public
No
Summary
[ ]Fix your misaligned drawer tracks, kitchen drawer tracks that fall out, bad roller drawer tracks and drawer track rollers using a 3d printed spacer.

Tools

  • Phillips Screwdriver general x1 added.

Parts

  • 3D printed universal drawer track spacer x1 The spacer is designed for use on either side. pick your required width: 1mm-6mm. One spacer can be used on either side for better drawer alignment and up to 12mm of gap adjustment added.
  • Flat head wood screw x1 The original drawer screw may not be long enough after the drawer track spacer is added. Use a longer equivalent size screw to account for the spacer if needed added.

Flags

  • Dare To Repair added.
  • In Progress added.
  • Member-Contributed Guide added.

Steps

Step #: 1
Before
After
Step #: 2
Before
After
Step #: 3
Before
After
Step #: 4
Before
After
Step #: 5
Before
After
Step #: 6
Before
After