Skip to main content

Changes to iPad 2 Wi-Fi EMC 2415 Front Panel Adhesive Strips Replacement Introduction

Edit by Andrew Optimus Goldheart

Edit approved by Andrew Optimus Goldheart

Deleted
Added
Unchanged
Introduction
Replace the adhesive securing the front panel to the rear case of your iPad 2 Wi-Fi. [ … ] Before you begin peeling and sticking tape, it's important to have clean adhesion surfaces on both the front panel and the rear case. Use a spudger to scrape off any large excess bits of original adhesive, then clean all of the gluing surfaces with a paper towel and rubbing alcohol or Goof Off. [ … ] Throughout this procedure, it is recommended to peel up each adhesive strip as needed.
Replace the adhesive securing the front panel to the rear case of your iPad 2 Wi-Fi. [ … ] Before you begin peeling and sticking tape, it's important to have clean adhesion surfaces on both the front panel and the rear case. Use a spudger to scrape off any large excess bits of original adhesive, then clean all of the gluing surfaces with a paper towel and rubbing alcohol or Goof Off. [ … ] Throughout this procedure, it is recommended to peel up each adhesive strip as needed.