1. To remove the lens, three T15 x 12.5mm screws must be removed by a T15 head screwdriver. The location of the other two screws are marked in red.
    • To remove the lens, three T15 x 12.5mm screws must be removed by a T15 head screwdriver.

    • The location of the other two screws are marked in red.

  2. After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place. After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place. After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place.
    • After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place.

  3. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  4. Remove battery by unplugging it from the circuit board.
    • Remove battery by unplugging it from the circuit board.

  5. Remove the circuit board by pressing on the mounting clips (shown in red circles) using the spudger. Remove the circuit board by pressing on the mounting clips (shown in red circles) using the spudger.
    • Remove the circuit board by pressing on the mounting clips (shown in red circles) using the spudger.

  6. Desolder the wires to free the circuit board.
    • Desolder the wires to free the circuit board.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Jeremiah Rhoades

Member since: 11/07/2017

365 Reputation

3 Guides authored

Team

IUPUI, Team S2-G3, Harley Fall 2017 Member of IUPUI, Team S2-G3, Harley Fall 2017

IUPUI-HARLEY-F17S2G3

3 Members

3 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 8

All Time: 224