Introduction

This guide will demonstrate the proper technique for removing and replacing the main brush for the vacuum.

Tools

No tools required.

Parts

Remove the dust bin by gently pressing the silver button on top of the vacuum until the bin releases.
  • Remove the dust bin by gently pressing the silver button on top of the vacuum until the bin releases.

Add Comment

Grip the bottom of the dust bin. Push up on the tabs as indicated by the yellow arrows. Empty contents of bin into waste receptacle and rinse with water as needed.
  • Grip the bottom of the dust bin. Push up on the tabs as indicated by the yellow arrows.

  • Empty contents of bin into waste receptacle and rinse with water as needed.

Add Comment

Flip over the device to access the brush cover. To remove the brush cover, push together the two snap releases on the right and left sides of the cover until it releases. Do not push the release snaps too close together. Doing so may cause them to break and the brush could fall out when in use.
  • Flip over the device to access the brush cover.

  • To remove the brush cover, push together the two snap releases on the right and left sides of the cover until it releases.

  • Do not push the release snaps too close together. Doing so may cause them to break and the brush could fall out when in use.

Add Comment

Grip the left side of the brush with the square end-piece and pull up until the brush pops out. Grip the left side of the brush with the square end-piece and pull up until the brush pops out.
  • Grip the left side of the brush with the square end-piece and pull up until the brush pops out.

Add Comment

When preparing a new brush, it is very important to make sure that the new one is equipped with the proper end-pieces. Take the round metal piece and slide it into the square rubber coating. Then, stick it on the end with the metal peg. Take the round metal piece and slide it into the square rubber coating. Then, stick it on the end with the metal peg.
  • When preparing a new brush, it is very important to make sure that the new one is equipped with the proper end-pieces.

  • Take the round metal piece and slide it into the square rubber coating. Then, stick it on the end with the metal peg.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Trent Treiber

Member since: 02/28/2017

201 Reputation

2 Guides authored

Team

USF Tampa, Team S2-G3, Nance Spring 2017 Member of USF Tampa, Team S2-G3, Nance Spring 2017

USFT-NANCE-S17S2G3

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 15

All Time: 93