Skip to main content

Introduction

If your selector bezel is cracked or broken and you would like to replace it, follow these steps.

Parts

  1. Pull the variable speed control knob from the front of the blender.
    • Pull the variable speed control knob from the front of the blender.

  2. Using a Phillips #1 screwdriver to remove the three 3/8" screws holding the selector bezel in place. Using a Phillips #1 screwdriver to remove the three 3/8" screws holding the selector bezel in place.
    • Using a Phillips #1 screwdriver to remove the three 3/8" screws holding the selector bezel in place.

  3. Pull the bezel from the base of the blender. Pull the bezel from the base of the blender.
    • Pull the bezel from the base of the blender.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Luke Kutz

Member since: 04/19/2018

345 Reputation

3 Guides authored

Team

Cal Poly, Team S25-G16, Maness Spring 2018 Member of Cal Poly, Team S25-G16, Maness Spring 2018

CPSU-MANESS-S18S25G16

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 96