Wolf Gourmet WGBL100S Control Board Replacement

Introduction

If your blender does not operate, try opening it as per this guide and checking the wires on the control board. If that yields no results, consider replacing the board if possible.

What you need

Step 1 Control Board

Wolf Gourmet WGBL100S Control Board Replacement, Control Board: step 1, image 1 of 2

Wolf Gourmet WGBL100S Control Board Replacement, Control Board: step 1, image 2 of 2

Flip the base of the blender upside-down.
Remove the four 1/2" long screws in the corners of the base using a Phillips #2 screwdriver.

Edit

Step 2

Using the metal spudger, pry off one half of each rubber foot.
Note that one side of the foot is glued down; pry off the other side.

Edit

Step 3

Using the same screwdriver, remove the next four 1/2" long screws in the holes under the feet.
Pull the base off of the blender.

Edit

Step 4

Pull off the plastic housing.

Edit

Step 5

Using the same Phillips #2 screwdriver, remove the two 3/4" long screws holding the control board in place.

Edit

Step 6

Using pliers, pull off all the connectors on the top.

Edit

Step 7

Pull or pry off the last connector block, then remove the control board.

Edit

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

with 5 other contributors

Cole Gillespie

Member since: 04/19/18

476 Reputation

2 Guides authored

Badges: 9

+6 more badges

Team

Cal Poly, Team S25-G16, Maness Spring 2018 Member of Cal Poly, Team S25-G16, Maness Spring 2018

CPSU-MANESS-S18S25G16

4 Members

5 Guides authored

Wolf Gourmet WGBL100S Control Board Replacement

Introduction

What you need

Step 1 Control Board

Add Comment

Step 2

Add Comment

Step 3

Add Comment

Step 4

Add Comment

Step 5

Add Comment

Step 6

Add Comment

Step 7

Add Comment

Author

Cole Gillespie

Team

Cal Poly, Team S25-G16, Maness Spring 2018 Member of Cal Poly, Team S25-G16, Maness Spring 2018

0 Comments

Add Comment

Embed this guide

Preview