VTech MobiGo Touch Learning System Screen Replacement

Step 1 Case

• Remove the battery covers and the four batteries.
Step 2



• Remove the four plastic caps with a metal spudger to expose the 6.0 mm Philips JIS #0 case screws.
• Remove the eight 6.0 mm JIS #0 case screws.
Step 3
• Using a plastic opening tool, separate the two pieces of the case carefully.
Step 4 Disassembling VTech MobiGo Touch Learning System Screen Enclosure
• Remove the three 4.0 mm Philips J0 screws holding the "L" shaped brackets in place.
Step 5
• Remove the three "L" shaped brackets and the spring.
Step 6
• Flip the device over and remove the three 4.0 mm Philips J0 case screws.
Step 7
• Separate the front and back of the case.
• Use a plastic opening tool if necessary.
Step 8 Screen
• Remove the 4 (3.4 mm Philips J0) screws holding the screen in
Step 9
• Remove the black tape
Step 10
• Remove the circuit board from the back of the screen.
• The circuit board has double sided tape on the back side holding it to the screen.
Step 11
• Peel the ribbon wire off of the circuit board. Now the screen should be free to remove.
Step 12
• Resolder the new screens ribbon cable on the the circuit board.
• Always be careful when soldering.

Author

with 3 other contributors

Daniel Kresge

Member since: 09/01/15

385 Reputation

4 Guides authored

Badges: 10

• 
• 
• 

+7 more badges

Team

USF Tampa, Team 8-3, Eyestone Fall 2015 Member of USF Tampa, Team 8-3, Eyestone Fall 2015

USFT-EYESTONE-F15S8G3

3 Members

17 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview