VTech Kidizoom Camera Connect Power Distribution Circuit Board Replacement

Step 1 Front Case



• Remove batteries and SD card before beginning disassembly!
• Locate the four plastic screw covers denoted by the markers and gently pry them up with the metal spudger.
Step 2



• Remove all four (11mm) screws with the Philips #0 screwdriver.
Step 3
• Remove the two battery cartridges located on the underside of the camera.
• Once cartridges are removed, use the metal spudger to pry open the top, bottom, and both sides of the camera.
Step 4
• Beware of the two black viewfinder lens falling out as you pry open the device!
• The device should now be open and ready for further repair and/or replacement parts.
Step 5 Motherboard
• Locate and remove the screws circled in the provided image with a Philips #0 screwdriver.
Step 6
• Unsolder the connection points on the motherboard.
Step 7
• Unsolder the connections to the right battery terminal. Removing the terminal allows easier access to the motherboard.
Step 8
• Carefully pull up on the motherboard and pink plastic underneath the motherboard. The pink plastic contains the display and is connected to the motherboard.
Step 9 Power Distribution Circuit Board
• Unsolder the wires connected to the power distribution circuit board.
Step 10
• Locate and remove the two screws that hold in the power distribution circuit board using a Philips #0 screwdriver.
Step 11
• Gently pull up on power distribution circuit board and remove it from the device.

Author

with 1 other contributor

Justin Sanchez

Member since: 02/08/16

520 Reputation

4 Guides authored

Badges: 11

• 
• 
• 

+8 more badges

Team

USF Tampa, Team 6-4, Eyestone Spring 2016 Member of USF Tampa, Team 6-4, Eyestone Spring 2016

USFT-EYESTONE-S16S6G4

4 Members

5 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview