VTech InnoTab 2s Back Panel Replacement

Step 1 Back Panel

• Turn your device to where the back panel is facing you.
Step 2



• Lift the Leg all the way up and twist the bottom to remove.
• Once the bottom part pops out the whole leg should just come off.
• Remove any game cartridge from the device.
Step 3
• Remove all of the plastic tabs on the device. These are covering screws that will need to be removed.
• These covers are made of hard plastic so they may be difficult to remove.
• There is a special tab in the cartridge cover that is made of rubber, make sure to not break this tab.
Step 4
• Remove all nine screws from the back of the device using a J0 bit.
• Remove the small battery.
Step 5
• Using a plastic opening tool, detach the backplate from the front piece.
• Do not use excessive force. Double check that you removed all the screws if the panel is not coming off easily.
• Once the backplate has been removed, you will have access to the circuit board.

Author

with 4 other contributors

Ricardo Espinosa

Member since: 10/06/16

221 Reputation

2 Guides authored

Badges: 7

• 
• 
• 

+4 more badges

Team

USF Tampa, Team 5-1, Lacy Fall 2016 Member of USF Tampa, Team 5-1, Lacy Fall 2016

USFT-LACY-F16S5G1

4 Members

12 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview